0

No products in the cart.

Trade Login

Knowledge Base

Step-by-step installation and setup guides for CCTV, access control and alarm systems, written by the Connixtech technical team.

Coming Soon

Guides in Preparation

  • Wireless Alarm Systems In preparation

    RF signal survey, device enrolment, battery maintenance.

  • Gate Automation In preparation

    Motor sizing, mechanical setup, photocells and force limits.

  • Intercoms, PA & Networking In preparation

    Intercom, PA system and PoE network guides.

FAQ

Common Questions

Where does the end-of-line resistor go?

At the far end of the loop, inside the last device on that zone. A resistor at the panel end defeats the purpose entirely, because anyone can cut the cable at the detector and the panel will still read sealed.

Read the guide: Alarm Zone Configuration and Wiring →
Do 3G alarm communicators still work in New Zealand?

No. All three New Zealand mobile operators completed their 3G shutdowns by 31 March 2026. Any 3G communicator must be replaced with a 4G unit. The panel will often show no fault, so this needs checking physically.

Read the guide: Alarm Communicator Setup (IP and 4G) →
Do I need a licence to install alarms in New Zealand?

Yes. Security system installation work is regulated under the Private Security Personnel and Private Investigators Act 2010 and requires the appropriate licence or certificate of approval.

Read the guide: Alarm Panel Programming Guide →
How long will a 2 TB NVR record?

Divide 2 TB by your daily storage figure. Eight 4 MP H.265 cameras at 4 Mbps recording continuously consume roughly 337 GB per day, so a 2 TB drive gives about six days. One camera on the same settings gives around 47 days. Motion-only recording extends both substantially.

Read the guide: NVR/DVR Setup Guide →
Why can't I port forward on this connection?

Most likely CGNAT — the site has no public IP of its own. Compare the router's WAN address against an external IP lookup; a WAN address in the 100.64.0.0/10 range confirms it. Use P2P instead, or ask the ISP for a public IP.

Read the guide: CCTV Remote Viewing Configuration →
What is the best height for a security camera?

Around 2.0 to 2.5 m where you need to identify faces, and 3.0 to 4.0 m for general overview. Higher is not better, because it trades face detail for coverage.

Read the guide: CCTV Camera Mounting and Positioning →
Is OSDP better than Wiegand?

For new work, yes. Wiegand transmits the credential in clear and is unsupervised, so a cut cable looks like an idle reader. OSDP with Secure Channel encrypts the link and reports when a reader stops responding.

Read the guide: Access Control Reader Wiring: Wiegand and OSDP →
Can 125 kHz proximity cards be cloned?

Yes, trivially. EM4100, EM4200 and HID Prox transmit a fixed number with no encryption or authentication. Writable blank tags that emulate them cost a few dollars and copying takes seconds.

Read the guide: Access Control Credentials: Programming, Formats and Cloning Risk →

Join the Connixtech Trade Partner Programme

Apply today and unlock exclusive trade pricing on New Zealand's best ELV security products. Applications are reviewed within 7–10 business days.

Apply for Trade Account →